Skip to content
📞 0217051247 📍 95 Victoria Rd, Plumstead, CT 🛒 Established 1985 🚛Free shipping on orders over R1500 T's&C's Apply
OSMO | UV Protection Oil Tints Natural with Film Protection Larch Satin 426 2.5l

OSMO | UV Protection Oil Tints Natural with Film Protection Larch Satin 426 2.5l

by OSMO
SKU 11600063
R 2,399.00 - R 2,399.00
R 2,399.00
R 2,399.00
R 2,399.00 - R 2,399.00
R 2,399.00

Natural Oil-Based UV Protective Tinted Finish - 426 Larch Satin 2,5l

  • Very water and dirt resistant
  • Reduces wood swelling and shrinkage
  • Resists growth of algae, mildew and fungal
  • Microporous, breathable finish which does not crack, peel, flake or blister
  • No sanding necessary for future applications

Surface Preparation

  • Wood surface must be clean, dry and frost-free (moisture content max. 20%)
  • UV-Protection-Oil Tints is ready to use
  • Do not thin
  • Stir well using a flat stirring stick or spatula before use
  • Ideally, surfaces are sanded no finer than a P120 grit grade of sandpaper
  • Sanding to finer grades will reduce required absorbency
  • If possible, and if the wood is absorbent, please apply first coat to all sides before installation
  • Fresh wood containing natural wood ingredients /extractives (eg:  Cedar, Teak, Mahogany or Iroko) are often less absorbent and need to weather off first before applying the product
  • Please refer to website ‘Suitability’ section for more details
  • Weathering helps ingredient rich wood become more absorbent and the wood finish adheres optimally
  • For renovation works, clean old microporous stains thoroughly – if necessary sand lightly
  • Clean and restore already greyed or weathered wood at the same time with Osmo Wood Reviver Power-Gel
  • Old paints and lacquers must be completely removed
  • As a general rule, wear a dust mask during sanding works
  • To maintain absorbency, avoid sanding surfaces finer than a P120 grit
  • Weather ingredient rich wood after sanding
  • The finished surface is influenced by several factors, including the condition of the wood
  • Therefore, a trial application is always required, especially for unfamiliar surfaces.
  • Softwood species like Pine or Spruce are more prone to blue stain, rot and insects
  • If desired, pre-treat these soft woods if possible on all sides with Osmo WR Base Coat

    Method of Application

    • With Osmo Flat Brush or Osmo Microfibre Roller, apply thinly along the wood grain and spread well
    • Allow to dry for approx. 12 hours under good ventilation
    • Then apply the second coat
    • Alternatively the second coat can also be carried out with UV-Protection-Oil Extra Clear
    • When recoating colour treated surfaces, or for renovation works, one coat applied to the clean and dry surface is usually sufficient

    Care

    • Regular Cleaning: Damp cleaning with Osmo Spray-Cleaner
    • Occasional Maintenance: If necessary, intensive cleaning and refreshing using Osmo Wood Reviver Power Gel or Osmo Gard Clean
    • Recoating: Simply re-apply one coat onto the clean and dry surface when signs of wear become visible